Got a question?

+44 (0)1924 445 862

Z&F AM-03 Turned Pin Processing 0.14-2.5sqmm

AM03 Z&F turned pin crimping machine
AM03 Z&F turned pin crimping machine

Z&F AM-03 Turned Pin Processing 0.14-2.5sqmm

Z&F AM-03 Turned Pin Processing

The stripper-crimper Z&F AM-03 Turned Pin Processing is an electro pneumatically driven machine for rapid and reliable processing of loose turned male and female pin contacts. The contacts are automatically fed by a vibratory unit which is mounted on top of the machine.

The Z&F AM-03 Turned Pin Processing machines may be adapted to different contacts or wires using the corresponding tools. Processing tuned pins is difficult because the wire entry funnel is very small. Manually inserting the wire takes time and effort to do properly. The loaded crimp must then be carefully crimped without moving the wire out of the funnel. traditionally this has been done with hand crimp tools or pneumatic crimping heads using a hex type crimp. The Z&F AM-03 Turned Pin Processing machine uses a quad crimp system which is set up perectly for each crimp type. This pushes the tool into the pin rather than just crimping a hex shape on to the outer surface.

The Z&F AM-03 allows the operator to push an unstripped wire into the machine. From there the AM-03 takes over. the full cycle grips the wire, strips the insulation loads a loose piece contact from the holding hopper then crimps it onto the end of the stripped wire. There are also Z&F AM-03 Turned Pin Processing options to add crimp force monitoring to fully control the end result.

Please see the movie demonstration option below. We have over 30 years experience supplying wire processing and crimping solutions throughout the UK and Europe. If you have a particular manufacturing issue we have the solution.

Contact us now to arrange a site visit, quotation or demonstration.

Enquire About This Product

Product Description

Z&F AM-03 Turned Pin Processing

The stripper-crimper Z&F AM-03 Turned Pin Processing is an electro pneumatically driven machine for rapid and reliable processing of loose turned male and female pin contacts. The contacts are automatically fed by a vibratory unit which is mounted on top of the machine.

The Z&F AM-03 Turned Pin Processing machines may be adapted to different contacts or wires using the corresponding tools. Processing tuned pins is difficult because the wire entry funnel is very small. Manually inserting the wire takes time and effort to do properly. The loaded crimp must then be carefully crimped without moving the wire out of the funnel. traditionally this has been done with hand crimp tools or pneumatic crimping heads using a hex type crimp. The Z&F AM-03 Turned Pin Processing machine uses a quad crimp system which is set up perfectly for each crimp type. This pushes the tool into the pin rather than just crimping a hex shape on to the outer surface.

The Z&F AM-03 allows the operator to push an unstripped wire into the machine. From there the AM-03 takes over. the full cycle grips the wire, strips the insulation loads a loose piece contact from the holding hopper then crimps it onto the end of the stripped wire. There are also Z&F AM-03 Turned Pin Processing options to add crimp force monitoring to fully control the end result.

Please see the movie demonstration option below. We have over 30 years experience supplying wire processing and crimping solutions throughout the UK and Europe. If you have a particular manufacturing issue we have the solution.

Contact us now to arrange a site visit, quotation or demonstration.

Stripping And Crimping Range Min 0.14mm sq Stripping And Crimping Range Max 2.5sqmmsDrive Electro-pneumatic Power Supply Single Phase 230V 50-60Hz 184VA Air Pressure 5 bar Cycle Time 4.0 Seconds Dimensions W=530mm H=460mm D=400mm Weight 40kg

Movie Demonstration